Company Profile

Hose Water Meters for Agricultural Landscape and Turf Irrigation Volumetric Timers

Quick Answer: Hose water meters with volumetric timers handle small nursery benches, garden beds, and turf laterals. For main lines above DN25 or for signal output to a controller, Silver Automation Instruments (Silver Instruments) recommends an electromagnetic flow meter with 4-20 mA HART. Send us your pressure (bar), temperature (°C), pipe size (DN), and flow range (m3/h) for a quote.

Many landscape contractors start with a hose water meter and a timer to batch irrigation water. That works for one hose or a small drip zone. Problems appear when the site grows. Timers drift, total volume is unclear, and no signal reaches the control room. We have seen this on customer sites in Australia and Saudi Arabia.

Where Hose Water Meters and Volumetric Timers Fit

In agricultural landscape and turf irrigation, a DN15 or DN20 hose water meter with a volumetric timer suits manual watering points. A nursery in Queensland used ten such units on separate benches. Each timer delivered 40 liters per cycle. The main supply line still needed a master meter for total consumption. A small plastic hose meter was not suitable there. Pressure drop and no analog output were the two issues.

The nursery installed a Silver Instruments EMAG series electromagnetic flow meter on the DN50 inlet. The meter sent total volume and real time flow rate to a PLC. The operator could compare each bench timer against the master total.

Key Parameters for Turf and Landscape Irrigation

Always specify flow range before buying. A DN15 hose meter may read 1 to 30 liters per minute. A DN50 main line can run from 5 to 40 m3/h. A wrong flow range causes accuracy drift. Silver Instruments electromagnetic flow meters need water conductivity of 20 µS/cm or higher. Most bore water and town water in Southeast Asia and Australia meet that level.

Pressure matters too. Hose water meters often operate at 4 to 6 bar. Pumped lines at 10 bar or 16 bar need a flanged industrial meter. If the same line carries fertilizer solution at 40 to 60 °C, specify a meter with PT100 temperature compensation or a suitable temperature rating.

Matching Silver Instruments Flow Meters to Irrigation Lines

For DN15 to DN25 hose outlets, a small positive displacement meter with pulse output can replace a basic hose water meter. It gives total volume and a pulse signal. For DN40 to DN200 main lines, choose the Silver Instruments EMAG series electromagnetic flow meter. It has no moving parts and handles dirty water from channels or ponds. For large DN250 to DN600 transfer pipes, the USONIC series clamp-on ultrasonic flow meter avoids pipe cutting.

Do not confuse the timer with the meter. A volumetric timer is a control convenience. A flow meter with pulse or analog output is a measurement device. For turf irrigation that needs batch control, select a meter with pulse output wired to the timer. Silver Instruments can supply an electromagnetic flow meter with 4-20 mA HART, pulse, and RS485.

Installation Points That Prevent Measurement Drift

Straight run matters. Electromagnetic flow meters usually need 5 DN upstream and 3 DN downstream. A hose water meter on a hose reel has no stable straight run. That is acceptable for rough volume checks. It is not acceptable for billing or zone verification. Air bubbles also create false totals. Install an air release valve before the meter on pumped lines.

Grounding is another detail. In PVC pipelines, an electromagnetic flow meter may need grounding rings or a grounding electrode. Low conductivity water makes ground contact more critical. Always share the pipe material with the inquiry. Concrete, PVC, and steel pipe each need a different installation kit.

Regional Experience in Agricultural and Landscape Projects

Silver Instruments supplied a dat